污水提升器

Sanimaster PE

Made in Germany

Compact sewage disposal unit　with plastic – or steel tank.

Application

HOMA Sanimaster PE, FE, VA compact sewage disposal units are suitable for pumping sewage and waste water from areas below the sewer level (see DIN 1986). With their large tank volumes and high performance submersible waste water pumps they are the ideal solution for the disposal from large private, commercial or public buildings, hospitals, schools etc.

The compact design allows a packed　installation with minimum space　requirement.

The horizontal pump position with the　straight-thru tank-pump discharge connection　avoids unnecessary elbows.　With flanged gate valves fitted between　the tank and the pumps, the twin pump　unit operates even with one pump disassembled　for maintanance or repair.

The tanks are available in different　materials with volumes from 180 up to

1000 litres.

DIN EN 12050-1: Conformity and　design approved and controlled by LGA,

certificate No. 0220119.

Pumped liquid: Clear water or　drainage water, waste water or sewage　containing soft solids. Max. liquid temperature:　35°C, short term up to 60°C.

Operation: Intermittent.

Design

Flood protected single or twin pump　lifting station consisting of:

Collecting tank: Odour and gas tight　tank.

Plastic tank:

Total volume 400 l, tandem installation　with two tanks up to 800 l.

Inlets: DN 150 horizontal (3x), DN 100　vertical.

Air vent DN 70.

Connection for diaphragm pump DN 50.

Cleaning cover with screw cap. Connections　for pneumatic level control and　float switch.

Steel tank, galvanized or stainless　steel:

Total volume 180 l up to 1000 l (larger　volumes on request).

Inlet: DN 150 horizontal. Air vent DN　70. Connection for diaphragm pump　BSP 11/2“F. Cleaning cover with screw　cap. Connections for pneumatic level　control and float switch.

Pumps: Single stage sewage　pumps. Horizontal installation, discharge　vertical.

Impellers: Enclosed single-vane　impeller (M) or vortex impeller (V).

Motors: Fully submersible, pressure　tight electric motors 400-415 V / 3 Ph.　Thermal sensors embedded in the　winding. Insulation class F. Degree of　protection IP 68. Large diameter stainless　steel rotor shaft, pre-lubricated　bearings.

Seals: Combination of two mechanical　seals (silicon-carbide) in a separate　oil chamber. Oil inspection from outside.Electronical seal probe fitted into

the oil chamber on request.

Explosion protection: All models are　available with explosion proof motors　according to II 2 G EEx de [ib] IIBT4.

Materials:

Collecting tank see tank types

Motor housing, Cast iron

pump housing, GG25/EN-GJL-250

impeller

Rotor shaft, Stainless steel

screws

Seal kit Perbonane

Equipment supplied

Tank with 1 pump or 2 pumps. Elastic　hose connections with bands for tank　inlet, connection tank-pump, air vent　and diaphragm pump. 1 Elastic unio　piece DN 100 per pump for discharge　connection (with flange DN 80 or DN　100 depending on the pump type).

Pneumatic level control. Electronic control　panel.